Elantra Sport Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
I recently purchased a set of take-off wheels at a price I couldn't pass up. They match stock specs in all areas other than offset. These wheels have a 60mm offset compared to our stock wheel's 55mm. They do clear the brakes and suspension, but I was thinking about maybe getting some 3mm spacers to push them out just a bit so that they are closer to stock. I am wondering if the stock lugs are long enough to add 3mm spacers? currently, I can get about 7.5-8 turns of the lug nut without any spacers. My plan is to switch between the stock wheels and this set, depending on tire needs. Appreciate any feedback you may have.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.