Elantra Sport Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hey guys and gals! I have been doing a bit of digging around on the forums and the general consensus has been that the factory EBCS is not very good. I had a look at SXTH Element's Pierburg unit, but apparently it doesn't fit the bill as well as the Borg Warner EBCS unit (it is also available more readily here in AUS). Has anybody had any experience installing the Borg Warner unit and if so, how difficult was the installation? Was the factory EBCS easily accessible? Was it entirely plug and play or was some minor tweaks needed to connect the hoses? Any insights would be well appreciated!
 

·
Registered
Joined
·
73 Posts
Borg Warner does not make solenoids. It's incorrectly named. Pierburg is the maker of the 'Borg Warner' unit, and it's incorrectly named, because that unit that everyone has been retrofitting on to their ES' is made for the Borg Warner EFR turbos. Pierburg is the maker of these solenoids. So the unit that SXTH is selling is the same unit spec as the 'Borg Warner'. Get the SXTH unit, and then consult with them on the install, as the unit does not come with instructions.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
Thanks for the helpful information mate! Will be sure to follow it up with SXTH!
 
1 - 3 of 3 Posts
Top