Elantra Sport Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
I'm on the budget right now, but fortunately I work with some good fabricators and welders, so I'm going to make my own 3" down pipe in stainless steel, but I need the bolt patter for the 3 bolts flange and for the 2 bolts flange. Anyone that upgrade the DP and have the OEM laying around that can verify these dimensions?
 

·
Registered
Joined
·
26 Posts
Discussion Starter · #2 ·
The dealer is asking $40 for just the 3 bolt gasket (p/n 282822b700)!!! Anyone with a downpipe on hand that can measure the distance between the bolts (center to center) for me?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top